Name : Birla
Time : 6/24/2013 2:17:32 PM
Title : How to adjust the sand making machine to reach the ideal partical size?
Question :

How to adjust the sand making machine to reach the ideal partical size?

Categories : Crusher Series
Reply :

 

After using sand making machine for some time, the hammer and the back plate will be normal wearing and the partical size of crushing machine becomes large.Therefore we need to make some simple adjustments for fine crusher which can reach the ideal particle size. The following are three kinds of adjustment:
 
1.Adjusting screw connects the back plate frame between the back plate and the body flange, by adjusting the nut on the screw screw to change the gap between the hammer and the back plate;
 
2.There is a adjustment round bar steel protruding from both sides behind the under back plate, the new sand making machine has adjustment screw of under back plate frame rear. By adjusting the nut on the screw, we can change the gap between the under back plate and the hammer;
 
3.Observing the degree of wear for the hammer of new sand making machine.If it excessive wear, we need to change sides of the hammer to continue to use.
Question: