NEWS
- Company News
- Kefid's impact crusher models
- Kefid single-cylinder hydraulic
- The equipment configuration and
- The future development of minin
- K series tire mobile crusher
- Bauma China 2020: Three new pro
- Basalt sand and gravel producti
- The crushing mechanism of impac
- The use of coal gangue and crus
- 325 mesh calcium carbonate powd
- Industry News
- The maintenance measures that i
- The standard of mechanism sand
- The technological processes of
- The technical advantages of Eur
- Concrete blocks recycling to bu
- A powerful tool for processing
- Stone crusher for railway proje
- The selection of crushing cavit
- The advantages of mobile sand m
- The solution to prevent corrosi
- Exhibition
- Special Report
- Faq
- How to maintain the production
- How to configure equipment for
- The composition of cement raymo
- I want to buy a coal mill with
- What equipment is needed for th
- What are the complete sets of e
- Regarding the waste disposal af
- What is the price of sand washe
- How much are the accessories of
- What is the reason for the slow
What are the precautions for the startup and shutdown of the ultra-fine mill?
Asker: MariusAsk date: 10/11/2018 10:27:11AM
Question: What are the precautions for the startup and shutdown of the ultra-fine mill?
Reply:
Dear Marius,
Before the ultra-fine grinding machine is started, it should be checked whether all the inspection doors are closed tightly. Check whether the gap between the jaws of the crusher meets the feeding size. Adjust the speed of the analyzer to reach the approximate grain size requirements. Then start up in order.
1. Start the bucket elevator;
2. Start the jaw crusher;
3. After the material is stored in the warehouse, start the analysis machine;
4, start the blower;
5. Start the main machine of superfine mill and start the electromagnetic vibrating feeder immediately after starting the host.
At this point, the ultra-fine mill grinding work begins. The operation sequence of the ultra-fine mill is as follows: start hoist → crusher → analysis machine → fan → main machine → feeder. When the ultra-fine mill is stopped, the machines should be shut down in the following order:
1. Close the feeder to stop feeding;
2. Stop the host after about one minute;
3. Stop the blower after blowing off the residual powder;
4. Turn off the analyzer.
The order of shutdown of the ultra-fine mill is: feeder → host → blower → analyzer.
Ultra-fine grinding mill is not allowed to refuel at any time during normal operation. To ensure reliable production, abnormal noise occurs in any part of the grinding mill, or the load suddenly increases, stop immediately to check and eliminate the malfunction, so as to avoid major accidents. When the power is turned on, the residual material in the mill is taken out, otherwise the current is too large when starting up, which affects the startup.
Regards!
Kefid
Kefid