Saving electricity for Raymond mill should rely on technology

At present, due to the lack of national coal resources and our country is industrial power, the power consumption is very large. You may have encountered a situation: there will appear the phenomenon of peak power in the evening , which gives our life bring a lot of inconvenience. For grinding machine manufacturers, it can save electricity little by little, so it is very necessary to master a few grinding mill's saving electrical technical operation, which can reduce the cost of the manufacturer.

Firstly, the staff should remember this: if the feed speed is too quick, it will increase the grinding machine's operating load, resulting in excessive power consumption. If the feed speed is too slow, it will cause equipment idle, and cause the waste of electricity. The correct way is: try to keep feeding speed constant even, don't too fast and do not too slow.

Secondly, if feed particle size is too large, the residence time is longer in ground indoor, the grinding operation time is also more long, the power loss is bigger also. So feed particle size should be controled moderately, not too thick, and do not carefully. This is a kind of good method to save electricity.

Finally, to avoid raymond mill appear discharge gate blocking phenomenon, and cause internal entities large product powder, operating at the natural resistance increase, resulting in the waste of electricity. So, we should always keep a unobstructed discharge.