Home >> News >> FAQ >>

How does the new crusher prevent rust?

Asker: Priya
Ask date: 12/5/2019 02:15:21PM
Question: How does the new crusher prevent rust?


Reply:

Dear Priya,

1. During crusher storage or seasonal shutdown, let the crusher run for at least 5 minutes at least once a month to ensure that the bearings remain properly lubricated. If the crusher cannot be operated during storage, the crusher flywheel must be manually rotated 3 to 4 times to ensure that the bearings are properly lubricated. If necessary, grease the bearings.
 
2. If the flywheel has been removed from the eccentric shaft, the contact surface between the flywheel and the shaft should be coated with a preservative.
 
3. If the movable jaw body has been removed from the frame, in order to prevent debris from entering the bearing seat, the seal should be coated with sufficient grease. The bearing seat contact surface and the frame, the bracket contact surface and the bracket contact surface, and the tie rod holes on the frame should also be coated with a preservative.
 
4. The crusher and its removed parts should be stored on a stable support to prevent contact with the ground.
 
5. When the crusher is taken out from the storage place, the paint condition must be checked and repaired if necessary. Before assembling the crusher, the preservative should be removed from all contact surfaces.
 
Regards!

Kefid

Top